Acer AL2016, Руководство по обслуживанию

Страница: 17 / 45

Acer Service Manual
3.6 VGA Cable Detect Test
If VGA cable of LCD monitor isn’t connected to video pattern generator or PC, “NO SIGNAL” should
be shown on screen.
3.7 Hi-Pot test
Test condition:
a. high voltage 2.3KV(DC)
b. leakage current 10mA
c. rising time 1 sec.
d. test time 3 sec.
3.8 Grounding Test
Test condition:
a. test current 30A / 2 sec
b. impedance < 0.1 Ω
3.9 Bumping Test
3.9.1 Test mode: 1680x1050 @ 60 Hz;
3.9.2 Test pattern: pattern #1 of crosshatch (GENERAL-1)
3.9.3 To shock LCD monitor lightly at the center of rear cover and edges with 1~2kg/cm2 force for
three times, no abnormal phenomenon is found on panel screen.
4.
DISPLAY CHECK
4.1 Panel Flicker Check
Connect LCD monitor to PC, set LCD monitor to be timing of 1680x1050 @ 60 Hz, adjust brightness to
be default value (brightness at maximum), execute “Auto” function, and then check picture of shut
down under windows 98 operating system, or flicker-pattern of pixel on-off. It should be that no flicker
be found on panel screen.
4.2 Panel Defect Inspection
This item should follow IIS
4.2.1 Test mode: 1680 x 1050@60Hz
4.2.2 Test pattern: Crosshatch/Full white/Red/Green/Blue/Black/16 color bar/64 gray bars
4.2.3 Display quality must be (according to DIN 13406-2 pixel fault class II)
Defect Type Specification Major Minor
Bright dot defect
≤ 3pcs
˙
Dark dot defect
≤ 4pcs
˙
Total bright and dark dots
≤ 5pcs
˙
Bright Dots – 2 Adjacent B
N ≤ 1 pair
˙
Bright Dots – 3 or more
Adjacent
N ≤ 0 pair
˙
Black Dots – 2 Adjacent B
N ≤ 1 pair
˙
Black Dots – 3 or more Adjacent
N ≤ 0 pair
˙
Distance between defect dots
L ≥ 15 mm
˙
Distance between Dark dots
L ≥ 15 mm
˙
Note 1: Dot defect is defined as the defective area is not larger than 50% of the dot area. Bright Dot is
defined 5% transmission ND filter.
Note 2: Light Leakage: There shall not be visible light around the customer’s bezel after assembly in
normal View angle.
16