Acer AcerPower F5, Руководство по обслуживанию, Страница: 53 / 118

Chapter 2 47
Parameter Description Options
ACPI Function This item allows you to enable or disable the ACPI
function Enabled
Disabled
ACPI Suspend Type This item specifies the power saving modes for ACPI
function. S1(POS): The S1 sleep mode is a low power
state. In this state, no system context (CPU or chipset)
is lost and hardware maintains all system context. S3
(STR): The S3 sleep mode is s power-down state in
which power is supplied only to essential components
such as main memory and wake-capable devices and
all system context is saved to main memory. The
information stored in memory will be used to restore
the PC to the previous state when an wake-up event
occurs. S1 (POS) : Set ACPI suspend
type to S1/POS(Power On
Suspend).
S3 (STR) : Set ACPI suspend
type to S3/STR
HDD Power Down Mode This setting controls how long a hard disk drive must
be left idle before ir spins down. Disabled
Standby
Suspend
Soft-off by PWR-BTTN This feature allows users to configure the power button
function. Instand-off : Press down
button then power off instantly
Delay 4 Sec. : Press power
button 4 sec. to power off.
Enter suspend if button is
pressed less than 4 sec.
PWRON After PWR-BTTN Under ACPI, you can create a software power down. If
the item is set to Instant-Off, then the power button
causes a software power down. If the item is set to
Delay 4 Sec, then you have to hole the power button
down for 4 seconds to cause a software power down. Delay 4 Sec
On/Off
Power On by Ring An input signal on the serial Ring Indicator (RI) line (in
other words, an incoming call on the modem) awakens
the system from a soft off state. Disabled : Disable Power On
by Ring function
Enabled : Enable Power On
by Ring function
Wake-Up by PCI Card This option allows the activity of the PCI devices to
wake up the system from S3 sleep state. Disabled
Enabled
USB KB Wake Up From S3 This option allows the activity of the USB devices
to wake up the system from S3 sleep state. Enabled
Disabled
Resume by Alarm You can set “Resume by Alarm” item to enabled and
key in Data/Time to power on system Disabled : Disable this
function
Enabled : Enable alarm
function to Power On system
If RTC Alarm Lead To Power
On is Enabled.
Date (of Month) Alarm :
Everyday, 1~31
Time (hh:mm:ss) Alarm:
(0.~23):(0~59):(0~59)