Acecad DigiMemo 692, Руководство пользователя

Страница: 23 / 31

17
Appendixes
Replacing the Ink Cartridge of the Digital Pen
Two replacement ink cartridges are stored in the cartridge
compartment of the digital pad. To open the cartridge
compartment cover of the pad, slide it outward while pressing
the raised dots on the middle of the cover.
To replace the ink cartridge of the pen, you may use a small clip
to gently pull the old one out. Then insert a new one and press
the cartridge tip firmly against a hard surface until it snaps into
place.
You can also use the clip hole in the cartridge compartment to
replace the ink cartridge.
1. Hold the digital pen upright and insert the cartridge tip into the wider
side of the clip hole.
2. Gently push the pen horizontally towards the narrow side of the clip hole
to as far as it can reach.
3. Gently pull out the ink cartridge from the pen.
4. Insert a new one. Then press the cartridge tip firmly against a hard
surface until it snaps into place.
Purchasing New Replacement Ink Cartridges
The specification of ink cartridge used for the digital pen is 0.09" / 2.3 mm (Diameter) x
2.64" / 67 mm (Length).
Note! The following ink cartridges have been tested and approved for use with the
digital pen:
Note! The material of some ink cartridges may affect the performance of the digital
pen. Some ink cartridge with the different outside dimensions may damage the
digital pen.
Replacing the Battery in the Digital Pen
Even though the battery of the digital pen can last approximately 14 months, the battery
in the pen may be exhausted if any of the following situations occurs. If so, please
replace the battery.
Brand Model
ACECAD ink cartridge series
Cross 8518-1
Lamy M21
Sterling 01800T
SPALDING RFR80A
STAEDTLER 930-ASBK3V
1
2
3
Clip Hole