Troubleshooting
Page 27
Concentration is unobtainable through the instruments control. Simply
open or close the vial adjust knob to correct. If the vial is nearly expired,
the vial may need to be replaced with a fresh vial to obtain higher
concentrations.
Sample draw instruments can be calibrated utilizing the GENie QC-1 by
filling a gas bag and drawing the calibration gas from the bag.
accompanied by an audible beep.
If the source is not initially detected by the processor, the unit will display
appen
because a connection to the source is not made, or due to a failure of the
circuit board on the generating source. Remove the source. Ensure that
the electrical contacts are clean, then re-attach the source.
accompanied by an audible beep.
GENie O3: The source calibration life has expired, and the display ill show
the unit will still function normally despite calibration frequency being
exceeded.)
GENie QC-1: The calibration of the QC-1 is mated to the main module.
You will see a sticker on the QC-
SN G-
-1 to a different main module will
produce this display. In this case, the unit will turn itself off rather than
generate inaccurate calibration gas. Once you connect the QC-1 to the
correct main module, the error will go away.
indicating that the QC-1 has generated over 100 hours of calibration gas
and source calibration is required. In this case, the unit will continue to
operate normally. The message is simply a reminder.
accompanied by an audible beep.
Replace the batteries or switch to AC power.
