Charging Battery.
Œ
Connect the supplied cable’s normal USB
connector (bigger end) to any standard USB-
Power adaptor or any computer’s USB port
(make sure the computer is powered on).
Open up the lid on the RIGHT side of the
headset, you will notice a small chamfer on the
lid. (As the illustration on the left)
Note that Mercury doesn’t come with a power
adaptor, but it can be charged via any standard
USB-Power adaptor or USB ports on computers.
Ž
Connect the other end of the cable (smaller micro-USB end) to the
on the headset, make sure it’s completed inserted firmly.
The
next to the port will light up immediately. (If not, please
check the power adaptor is connected to a wall-jack or the computer is powered on).
LED will remains RED when charging. It will turn BLUE when fully charged. To
avoid using the Mercury during charge, the unit will not operate once connected to a
power source.
(A)Charging
Port
(B)headset LED
Pairing Mode.
Œ
to Mercury, within 1 meter distance.
Turn on bluetooth pairing / searching mode on your device.
Ž
Make sure Mercury is turned off*, and press and hold the
for more than 5 seconds until the
(as shown in above section) flashes blue and red.
Go to your pairing device and look for “Mercury” under the
bluetooth searched list, and select connect.
When successfully paired, the
will turn blue
and flash.
Place your mobile phone / tablet / computer for pairing close
(C)
Multifunction Button
(B)
headset LED
(B) headset LED
Check and make sure your device, be it computer,
tablet or mobile phone supports bluetooth.
A
B
C
Pairing Mode.
* If you released the
(less than 5 seconds) before
Mercury enters pairing mode or if Mercury keeps on flashing only blue after you’ve
press and hold the button for more than 5 seconds, it means that it is still connected
to another device and operating.
You will need to turn off the device, by pressing the same button for two seconds
and release the button. If the
turns red for a few seconds, this
indicates Mercury has powered down. Repeat step 3 on the previous page for
pairing.
** On some pairing devices, a Pin Code is required for bluetooth pairing, simply
input “0000” (four zeros) when requested.
(C) Multifunction Button
(B) headset LED
Wearing Method.
While Mercury is designed to fit most users ear sizes, with it’s three sizes of silicon
sleeves and memory foam, some users prefer a firmer, stabler hold. Simply add the
as below:
stabilizer rings
Œ
Remove the existing silicon or memory
foam earbud.
Insert the stabilizer ring between the
nozzle and the earbud.
Ž
Rotate the stabilizer ring to find the
perfect angle for firm hold to your ear.
Make sure you wear your Mercury according to the Left/Right markings on the
headset, and
the cable should always be rested behind your neck.
Memory Foam.
Before inserting a memory foam
earbud in your ear, squeeze and gently
twist it to the smallest size, and allow it
to slowly regain its form inside your ear.
Once the foam regain its size (about 10
seconds), it will have molded with the
shape of your ear canal to a perfect fit.