ENDO-CVT FLOW ADJUSTMENT
The AccuAir ENDO-CVT end caps have flow adjustment screws to control the rate of airflow between the air springs and the
solenoid valves. These allow speed adjustment of each corner of the car independently, both up and down, so you can adjust the
front and rear to lift and lower at the same speed.
Each air spring port on an ENDO-CVT tank cap has adjuster screws for inlet and exhaust above and below (respectively) the
push-to-connect fitting (see Figure 2). Each screw has 10 turns of adjustment from fully open (top) to fully closed (bottom).
Adjustment is nearly linear for most of the range. For example, starting 2 turns from the bottom and backing out the adjuster 2 turns
(4 turns total) will almost double the flow.
The ENDO-CVT has been shipped from the factory with all of the flow control screws set to maximum speed (top). You can choose
to slow down the speed of a desired air spring in a desired direction by turning the screw clockwise toward the bottom. Match the
number of turns for the paired air spring and direction (i.e., 2 turns in for the left rear “UP” should be matched at 2 turns in for the
right rear “UP”).
ENDO-CVT FLOW ADJUSTMENT
Figure 10:
ENDO-CVT flow adjustment behavior
Turns from bottom
Flow Rate (% of Maximum)
0
100.00%
90.00%
80.00%
70.00%
60.00%
50.00%
40.00%
30.00%
20.00%
10.00%
0.00%
2
4
6
8
10
12
!
NOTE:
The e-Level system will need to be
RE-CALIBRATED
after
flow adjustment is completed.
Page 11
ENDO-CVT Instructions V1.
2
AccuAir Suspension 2018
