Accton Technology WN3501C, Быстрое руководство по установке

Страница: 12 / 50

11 Mbps Wireless USB Adapter
4
Hardware Installation
Attaching the Clip (Optional)
1. Slide the open end of the clip under the two lips (at the USB port end) in the
square slot at the rear of the WN3501C.
2. Press the two lugs into the slots until they click into place.
3. To remove the clip, push in one of the lugs and pull the clip away from the
WN3501C body. The other lug should slip free.
Attaching the Magnets (Optional)
1. Peel the protective paper off the magnets and place the sticky side of the
magnets into the circular holes at the rear of the clip.
2. Press firmly.
Warning: Sticking magnets to a notebook screen will damage the screen.
Attaching the Velcro (Optional)
1. Peel the protective paper off the Velcro circles and firmly press the circles into
the circular holes at the rear of the clip.
2. Temporarily hold the WN3501C in the desired location and check the signal
quality is acceptable. Peel the protective paper off the Velcro strip and stick the
strip in the chosen location.
Attaching the USB Cable
1. Select an available USB port on the PC.
2. Carefully insert the USB cable’s Type-A plug (i.e., the flat plug) into the USB port
and press until it is firmly seated in the port. Insert the other end of the cable into
the WN3501C.
Warning: The plugs will only go into their respective slots one way. If the
plugs do not comfortably enter the slots, turn them around and try
again.