Accton Technology CheetahSwitch Workgroup-3514F, Руководство по управлению

Страница: 20 / 114

Using the System Configuration Program
2-10
IP Configuration
Use the IP Configuration screen to set the bootup option, or configure the switch’s IP
parameters. The screen shown below is described in the following table.
Network Configuration : IP Configuration
========================================
Interface Type : Ethernet
IP Address : 10.1.113.29
Subnet Mask : 255.255.0.0
Gateway IP :
IP State : USER-CONFIG
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move, other keys to make changes.
Parameter Description
Interface Type Indicates IP over Ethernet.
IP Address IP address of the stack you are managing. The system supports SNMP over UDP/
IP transport protocol. In this environment, all systems on the Internet, such as
network interconnection devices and any PC accessing the agent module (or
running AccView) must have an IP address.
Valid IP addresses consist of four numbers, of 0 to 255, and separated by periods.
Anything outside of this format will not be accepted by the configuration program.
Subnet Mask Subnet mask of the switch you have selected. This mask identifies the host
address bits used for routing to specific subnets.
Default Gateway Gateway used to pass trap messages from the system’s agent to the management
station. Note that the gateway must be defined if the management station is
located in a different IP segment. The default value is null.
IP State Specifies whether IP functionality is enabled via manual configuration, or set by
Boot Protocol (BOOTP). Options include:
USER-CONFIG - IP functionality is enabled based on the default or user specified
IP Configuration. (This is the default setting.)
BOOTP Get IP - IP is enabled but will not function until a BOOTP reply has been
received. BOOTP requests will be periodically broadcast by the switch in an effort
to learn its IP address. (BOOTP values can include the IP address, default
gateway, subnet mask, and TFTP server IP.)