31
ATWn Connect Message Control
This command controls the format of CONNECT messages. The parameter
value, if valid, is written to S31 bits 2 and 3. Note that the Wn
command can be overridden by register S95 bits(see S95 description).
ATW0 Upon connection, the modem reports only the DTE speed(e.g.,
CONNECT 57600). Subsequent responses are disabled.(Default)
ATW1 Upon connection, the modem reports the line speed, the error
correction protocol, and the DTE speed, respectively.
Subsequent responses are disabled.
ATW2 Upon connection, the modem reports the DCE speed(e.g., CONNECT
28800). Subsequent responses are disabled.
ATXn Extended Result Codes
This command selects which subset of the result messages will be used
by the modem to inform the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. If the
user wishes to enforce fail tone detection, a "W" can be placed in the
dial string(see D command).Note that the information below is based
upon the default implementation of the X results table. Table 3-1
indicates the messages which are enabled for each X value.
If the modem is in facsimile mode(+FCLASS=1 or 2), the only message
sent to indicate a connection is CONNECT without a speed indication.
ATX0 Disables monitoring of busy tones unless forced otherwise by
country requirements; send only OK, CONNECT, RING, NO
CARRIER, ERROR, and NO ANSWER result codes. Blind dialing is
enabled/disabled by country parameters. If busy tone detection
is enforced and busy tone is not detected, NO CARRIER will be
reported. If dial tone detection is enforced or selected and
dial tone is not detected, NO CARRIER will be reported
instead of NO DIAL TONE. The vale 000b is written to S22 bits
6, 5, and 4, respectively.
ATX1 Disables monitoring of busy tones unless forced otherwise by
country requirements; send only Ok, CONNECT, RING, NO CARRIER,
ERROR, NO ANSWER, and CONNECT XXXX(XXXX=rate). Blind dialing
enabled/disabled by country parameters. If busy tone
detection is enforced and busy tone is detected, NO CARRIER
will be reported instead of BUSY. If dial tone detection is
enforced or selected and dial tone is not detected, NO
CARRIER will be reported instead of NO DIAL TONE. The value
100b is written to S22 bits 6, 5, and 4, respectively.
ATX2 Disables monitoring of busy tones unless forced otherwise
by country requirements; send only OK,CONNECT,RING,NO CARRIER
,ERROR,NO DIALTONE,NO ANSWER, and CONNECT XXXX. If busy tone
detection is enforced and busy tone is detected, NO CARRIER
will be reported instead of BUSY. If dial tone detection is
enforced or selected and dial tone is not detected, NO DIAL
TONE will be reported instead of NO CARRIER. The value 101b
is written to S22 bits 6,5,and 4,respectively.
ATX3 Enables monitoring of busy tones; send only OK,CONNECT,RING,
NO CARRIER,ERROR,NO ANSWER, and CONNECT XXXX. Blind dialing is
enabled/disabled by country parameters. If dial tone detection
is enforced and dial tone is not detected. NO CARRIER will be
reported. The value 110b is written to S22 bits 6, 5, and 4,
respectively.