5
5.
Fitting
1.
Identify all components:
1.
CommunityBed Bed Lever
2.
2 x M8 Nyloc Nuts
3.
4 x M8 Plain Washers
4.
2 x M8 x 50mm Hex Head Bolt
5.
2 x Bolt Cap
2.
Additional tools required:
1.
2 x 13mm spanner
3.
Check that the delivery is complete and whether
any visible damage has occurred to the
CommunityBed Bed Lever during transport.
If parts are missing or there is visible damage,
contact Accora Customer Service.
4.
Make sure there is no obstruction to the Bed Lever
fitting. Fit the Bed Lever to the bed frame in
accordance with the positioning in Section 4:
5.
Clamp the CommunityBed Bed Lever to the frame
of the Community Bed with the bolts, washers and
nuts. Tighten the nuts and bolts with the 13mm
spanner.
6.
Cap the head of the bolt with the bolt cap.
WARNING
Fitting MUST be carried out by a suitably
trained and qualified person.
All functions MUST be tested and approved by
a competent person after assembly.
Assembly MUST take place in a clear,
uncluttered area and children and pets
should be kept away.
The CommunityBed Bed Lever MUST NOT be
fitted while the bed is in use, i.e. has a person
on the bed.
The Bed Lever MUST be fitted in accordance
with the Positioning instructions in Section 4 of
this manual.
Never use more than one CommunityBed Bed
Lever on each side of the bed.
1
2
3
5
3
4
3
4
2
5
