3
1 .Remove
the
existing
3.Route
the
light control’
s wires
through
the large gasket holes.
4.Twist the
junction
box
wires and
wires
together as
shown.
Secure
with
wire
connectors.
White
to
White
Black
to
Black
Junction box ground wire to
green ground screw on
xture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
Install the Light
1.Align the light
control
cover
plate
and
plate
gasket. Secure with
the mounting bolt.
4 To avoid water damage
and
electrical
shock,
keep heads holders below horizontal.
5.Adjust the heads by loosening the lock
nuts but do not rotate the heads more than
180°from the factory setting.When screwing
in the heads,do not overtighten.
Keep heads
at least
1" (25 mm) from the
sensor. Do
not allow
the
s
d
a
e
h
to block
the lens.
3.If a wet location
junction box
was
not
used,
caulk
the wall plate mounting surface
with silicone
sealant.
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
fixture.
fixture
light
2.Install the mounting strap as shown using
two screws that fit your junction box.
cover
Lock Nut
Lens
40 ft.
(12 m)
8 ft.
(2.4 m)
Maximum Range
Maximum
Coverage Angle
Bottom of Sensor
Avoid aiming the control at:
•
Objects that change temperature rapidly,
such as
heating vents and air conditioners.
These
heat sources could cause false triggering.
•
1.
Turn on the circuit breaker and light switch.
NOTE:
Sensor
has a 40
second warm up period
before it
will
detect motion. When
turned on, wait 1
minute.
2.Turn
the
RANGE
control to the medium
position
(halfway between MIN and MAX),
and
the
ON-TIME
control to the
TEST position.
first
A reas where pets or traffic may trigger
the control.
.Nearby large,light-colored objects reflecting
light may trigger the shut-off feature.Do not
point other lights at the sensor
MAX
MIN
RANGE
ON
-TIME
TEST 1
5
MINUTES
180°
Test and Adjustment
NOTE:
If fixture is mounted higher than 8 ft.(2.4m).
aiming the sensor down will reduce coverage distance
3.Loosen
the clamp screw in the
sensor
ball joint
and gently rotate the
sensor.
4.Walk through
the coverage area
noting where
you are when
the lights
turn on
head up
down,
or sideways
to change the coveragearea.
Keep the sensor
at least 1" (25 mm) away from the bulbs.
5.Adjust
the
RANGE
as
needed.
RANGE
set too
high may
increase false
triggering.
6.
Secure the
sensor
head by tightening the
clamp screw.
Do not overtighten
the
screw.
7.Set
the
amount
of TIME
you want the lights
to
stay on
after motion is detected (1
or
5 minutes).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Least Sensitive
Most Sensitive
WARNING - Risk of re. Do not aim the heads
at a combustible surface within 3 ft. (1 m).
The detector is less sensitive to motion coming
directly at it
(also ,the LED will flash
several times when motion is detected).
Motion
Motion
Sensor
Move the sensor
2.Push the rubber plug firmly into place.
