![background image](http://html1.mh-extra.com/html/acclaim-lighting/flex-one-exterior-series/flex-one-exterior-series_user-manual_3707425011.webp)
9
www.acclaimlighting.com
TO FIT THE FLEX ONE TAPE
1 If necessary, cut the channel to the required length. Remove any resulting burrs.
2 Ensure the tape mounting surface within the channel is completely dry and clean.
3 Determine the length of tape required. Mark the positions at each end of the channel
where the tape will be placed.
Note: The molded feed cap on each spool is too large to fit within the
channel and will need to be located outside of the extrusion.
Note: Flex One tape can be cut every 1” (25mm), which
may slightly constrain the precise lengths of tape that
can be achieved. Therefore it may be beneficial to
center the tape within the channel to achieve an
even distribution (subject to the above note).
4 Cut the tape to the nearest marked cutpoint.
5 Note: If you are attaching the channel directly
to a surface, see ‘To surface mount directly’
on page 10
before
inserting the tape.
Carefully push the tape into the channel, starting at the marked position. The tape’s size
will cause an interference fit within the channel, keeping it in place without adhesive.
IMPORTANT: While pressing the Flex One tape into position, take care not to put
excessive pressure on the components or connections.
6 If necessary, use Dow Corning® 799, 1199 (or equivalent) silicone sealant to fully
encapsulate the power connections to protect against any moisture ingress.
FLEX CHANNEL - LOW PROFILE/RECESSED/TALL (FLX444/777/888)
There are three options within the Flex channel range to suit varying installation
requirements: A low profile option with no lens; a recessed channel for concealment within
surfaces and a tall profile channel that reduces light spill. The latter two channels have a
choice of clear, frosted or opal lenses. For channel dimensions, see page 26.
Options
Flex channel low profile
(4’ / 1.21m)
[FLX444]
Flex channel tall profile
(4’ / 1.21m)
[FLX888]
Flex channel recessed
(4’ / 1.21m)
[FLX777]
Tall profile lenses
(4’ / 1.21m)
[Clear: FLX825]
[Frosted: FLX813]
[Opal: FLX801]
Recessed lenses
(4’ / 1.21m)
[Clear: FLX727]
[Frosted: FLX715]
[Opal: FLX702]
Flat brackets/
joiners plus
2.5 x 10mm
wood screws
[FLX111]
Angled
brackets plus
2.5 x 10mm
wood screws
[FLX113]
+24
V
+24
V
+24
V
+24
V
+24
V
Not
rated for
walk-over
installations
Содержание Flex One Exterior Series
Страница 1: ...User guide Flex One Exterior...
Страница 2: ......
Страница 30: ...www acclaimlighting com...