Acclaim Lighting Dyna Accent, Руководство пользователя

Страница: 15 / 24

13
www.acclaimlighting.com
ADDRESSING FIXTURES
TO ADDRESS FIXTURES USING THE ACCLAIM LIGHTING XMT-350
1 Connect the XMT-350 to the DMX input line of either a single fixture or multiple fixtures in
a pre-arranged daisy chain configuration (see page 10).
2 Power on the fixture(s) and the XMT-350.
3 On the XMT-350, press the
MODE button, then use the arrow buttons to highlight the RDM
function and press the button to select. The XMT-350 will search for RDM devices and
after a short while the XMT-350 will display a list of all located fixtures:
ACTUAL ADDRESS:
PATCH TO ADDRESS:
OK CANCEL
001
001
DYNA ACCENT (001)
MAIN
DYNA ACCENT
DYNA ACCENT
DYNA ACCENT 005
009
012
PATCH OPTIONS 004/004
RESTART PATCHING
MAIN
DYNA ACCENT
DYNA ACCENT
DYNA ACCENT 005
009
012
PATCH OPTIONS 004/004
DYNA ACCENT 001
The fixture that is highlighted within the list should begin flashing its emitters to identify
itself.
4 On the XMT-350, press the right arrow button to change to the PATCH tab:
5 If necessary, use the up/down buttons to choose an alternative fixture.
6 Press the button to set the address for the currently highlighted fixture:
7 Use the up/down buttons to set the required DMX address and then press the button
to store it within the fixture.
8 The highlight will automatically move to the next fixture so that you can address it.
Repeat steps 5 to 7 until all fixtures are addressed.
Note: DMX addresses shown in brackets, e.g.
(001), have been temporarily assigned by the
XMT-350, but are not yet stored within the
fixture(s).
DMX CHANNELS
The number of DMX channels required per fixture depends on the model:
•
Fixed white models 1 DMX channel
•
Dynamic white models 3 DMX channels
•
RGBW and RGBA models 4 DMX channels