Acclaim Lighting Dyna Accent, Руководство пользователя, Страница: 10 / 24

8
www.acclaimlighting.com
FITTING A SNOOT
In installations where any light spill from the Dyna Accent must be eradicated from a nearby
surface, the optional 4” snoot is recommended.
Note: If required, a spread lens can be fitted together with the snoot, see page 7.
TO FIT A SNOOT
Note: This operation is best achieved with the Dyna Accent front face lying horizontal.
1 Using a 3mm Allen wrench (hex key), slightly loosen each of the four bolts that secure the
front hood to the main body of the fixture. Once all bolts have been suitably loosened,
remove all four of them plus their small washers and lift off the front hood.
2 Place the snoot over the Dyna Accent front face in replacement for the front hood.
Note:
There are drain holes located every 90 degrees around the snoot circumference, so it can be
attached in any orientation.
3 Fit the four bolts and their washers from the original front hood, and tighten sufficiently.
Snoot