Programming a Cue
First enable the EDIT mode and select the desired Cue by using the GO+ and GO- buttons. You see the
number of the current Cue in the bottom left-hand corner of the screen.
Use the command line interface (CLI) to change the value of the channel. The CLI is known from theatre
lighting consoles and provides a fast way of setting values for one or multiple channels.
Examples of the CLI's usage are:
Command
Function
1 @ 50 <ENTER>
Sets channel 1 at 50% (or at DMX value 50 when DEC unit is
selected)
1 + 2 @ <FULL>
Sets channel 1 and 2 at maximum value
1 <THRU> 3 @ 0
Sets channels 1 till 3 at minimum value
1 <THRU> 3 + 5 @ 0
Sets channels 1, 2,3, and 5 at minimum value
<ALL> @ 100 <ENTER>
Sets channels 1 till 1024 at 100% (or at DMX value 100 when
DEC unit is selected)
1 @ + 10 <ENTER>
Increases channel 1 value with 10
<ALL> @ – 20 <ENTER>
Decreases all channels' value by 20
Capture a Cue
Alternatively to programming a Cue through the CLI it is also possible to record a Cue from the DMX
input port or incoming Art-Net universes.
To capture from DMX, simply connect your external DMX-512 source and set it to output the desired
Cue, then press the DMX Capture button. Only the ;rst 512 channels will be recorded, channels 513 till
1024 are left unchanged.
For capturing from Art-Net please make sure that the universe settings for incoming Art-Net match the
universes at your Art-Net source. Press the Art-Net Capture button and all 1,024 channels are recorded
in the Cue.
Timing
You can specify the cross-fade time between two Cues by setting the Cue's fade time (expressed in
seconds). Also you can determine for how long the Cue should be active before advancing to the next
Cue by setting the hold time. If the hold time is set to 0, the Cue is set to Halt and will not automatically
go to the next Cue.
16
