Access 3260 Series, Инструкции по установке и эксплуатации

Страница: 3 / 14

1
INSTALLATION INSTRUCTIONS & OWNER’S MANUAL
(Refer to individual model sheets for specifications)
BEFORE BEGINNING INSTALLATION, CHECK THE FOLLOWING ITEMS
AND READ THE INSTRUCTIONS CAREFULLY.
CHECK ENTIRE UNIT FOR CONCEALED DAMAGE. If there is any damage, DO NOT INSTALL!
Shipping damages must be reported to the carrier immediately. All damage must be discovered
and reported prior to installation in order to have it covered under the warranty!
COMPARE COLOR OF UNIT WITH OTHER FIXTURES. If color is not sufficiently compatible with
fixtures, DO NOT INSTALL!
PLANNING THE INSTALLATION
1. Make certain the floor structure is level and adequate to support installation. See floor loading in
tub specifications.
2. Building codes require that a panel(s) be constructed to allow ample clearance for plumbing repairs
and pump service or removal. (Please refer to your local codes for regulations.)
3. Using the tub itself, or installation drawings, measure and mark locations for waste pipe, water
supply, wiring runs, and service access.
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all instructions and save these instructions.
WARNING!
Examine all plumbing for damage and water test before final installation. If
damage has occurred, call our Technical Service Department at 877-249-2388.
WARNING!
Alterations or modifications of the plumbing system without expressed written
authorization will invalidate all warranty claims.
WARNING!
Installation must comply with current local and state building, plumbing, and
electrical codes.
WARNING!
It is the responsibility of the installer or owner to determine code requirements
prior to installation.
WARNING!
Connections should be made by licensed plumbers and electrician.
IMPORTANT INSTRUCTIONS:
* Do Not lift by plumbing at any time! Lift by the tub deck.
* Tub must be supported by the subfloor and bedding, not by the tub lip.
* Run pump and test all functions and plumbing prior to finishing installation.
* Run pump only when water in tub is two inches over jets.
The plumbing system on all Access Tubs meets ETL, and ANSI standards at time of
manufacture. Any modifications to the plumbing system, including the pump, will void the warranty and approvals.
IMPORTANT SAFETY INSTRUCTIONS
PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, AND INJURY.
SAVE THESE INSTRUCTIONS!