Function Description
Relay operation (Pulse mode and Toggle mode)
Both relays can operate in Pulse Mode (suitable for access control) or Toggle Mode (suitable for
arming/disarming alarms, switching lights, machines….etc)
Every time a valid card/fob is presented or a Pin input is made in Pulse Mode, the relay will operate, for the
pre-set relay pulse time
Every time a valid card/fob is presented or a Pin input is made in Toggle Mode, the relay changes state, which
will not revert until a valid card/fob is re-presented or a Pin input is re-made
Anti Tamper Alarm
– Please the last page for this
The K401-IE uses an LDR (light Dependent Resistor) as an anti tamper alarm. If the keypad facia is removed,
or a sudden change in light source, the tamper alarm will bleep constantly
PROGRAMMING
Programming will vary depending on access confirguration. Follow the instructions according to your access
configuration
Programming 1 -------------------- Configure the K401-IE
Change the configure settings according to your application (optional). Multiple configuration settings can be
changed at one time: enter program mode, change the desired settings, then exit program mode
Set Master Code
The 4 digit Master Code is used to prevent unauthorized access to the system. To interface with the K401-IE,
the manager will need a Master Code (factory default code: 6666). We recommend immediate update and
recording of your Master Code
Programming Step
Keystroke Combination
1. Enter Program Mode
﹡
(Master Code) #
2. Update Master Code
0
（
New Master Code
）
#
（
Repeat New Master Code
）
#
3. Exit Program Mode
*
