Accelleron A200-H, Руководство по сборке

Страница: 12 / 24

Assembly Instructions / A238-H.. - A240-H..
4 Installing the turbocharger / 4.1 Inserting gaskets
© Copyright 2022 Accelleron Industries. All rights reserved. HZTL455311P0042_EN Rev. B May 2022
4 Installing the turbocharger
4.1 Inserting gaskets
The oil is supplied (02) and drained (03) through the bracket (01).
The necessary gaskets (05) must be integrated in the support plate. A suggestion for the slot
shape (04) is shown below. The gaskets are not included in the Accelleron scope of delivery and
must be provided by the enginebuilder.
u
Use O-ring gaskets with a cord diameter of at least 3.5 mm.
u
Integrate the slots in the contact surface of the bracket (01).
CAUTION
Oil leak
Damaged or improperly inserted gaskets lead to oil leaks.
u
Always use new gaskets and insert them carefully into the slot.
Fig. 5: Inserting the gasket
01 Bracket 05 O-rings
02 Oil supply 06 Pin (optional)
03 Oil drain CE Compressor end
04 Slot for gasket
(suggestion)
Pin (06) as installation safety device
Turbochargers can have an oil inlet either on their right or left side; the oil inlet position can be differ-
ent for the turbocharger fitted on the left and on the right engine bank.
A pin can be installed in every support as an installation safety device to prevent inadvertent incor-
rect fitting. This pin fits into the respective slot on the foot of the bearing casing. Instructions of the
enginebuilder must be observed.
Page
10
/
21