THE CONTROL PANEL
The control panel is normally installed on the lip of the spa for easy
and convenient access. Within the panel housing is a 4 digit LED
display used to communicate to the user spa temperature, TOD,
elapsed user time, programming, status - diagnostic and error codes
and messages. There are 2 different size panels. They are
interchangeable. the 2000 Series panel can have up to 7 keys, the
1000 Series panel will have at most 6 keys. These are membrane type
switches which when depressed generate a signal that the
microprocessor will interpret and act upon. The switches are labeled
and have specific functions. They are divided into 2 groups:
Device Control Group Pump(s), Air Blower & Spa Light.
Status Control Group: Up & Down Keys & the Set Key.
Note: if any of the keys is pressed and held closed for longer
than 20 seconds, that key will be disabled and becomes non
functional. After releasing the key, it will be reactivated after
20 seconds. This is to prevent a collapsed or defective key
from locking up the system.
DEVICE CONTROL KEYS
There are up to 4 device key, JETS, AIR, AUX & LITE. Your spa will
have at least one water pump. Optionally your spa may have an air
blower, a second and/or third pump and a spa light. It may also have a
mister or a fiber optic light setup. If your spa does not have a specific
device please disregard the function of that device.
Primary Water Pump
Each spa should have at least one primary water pump which is usually
a dual speed pump. The low speed is used to filter the spa. Also while
the spa is being heated or there is an error condition, the low speed
circulates the water and you will not be able to turn it off.
Page 7
