15
ARS-2030L/2032 Manual
3.2.2 Without an HDD
If you don’t install a 3.5” hard disk to your copy smart plus, the operation procedures
will be as follows.
l
When copying comes to an end, the passed CDs will eject automatically.
The default is eject automatically, but you can change it.
l
The failed CDs will remain in the writers. The default is keeping failed
CDs in the writers, but you can change it. You need to press the buttons on
the writers to take the failed CDs.
l
During operation do not press any button on your copy smart plus, because
interruption will harm the device, and CDs will be damaged.
l
Place a source CD into CD-ROM.
l
Switch to function 1 Copy by pressing
▲
.
Place blank CD disks into the
CD writers, and press
ENT
to start copying.
l
When copying comes to an end, the passed CDs will eject automatically.
The default is eject automatically, but you can change it.
l
The failed CDs will remain in the writers. The default is keeping failed
CDs in the writers, but you can change it. You need to press the “eject”
buttons on the writers to take the failed CDs.
A figure of ATA-66 cable layout is on the next page.