ADSP 8
10
10
7.1 Power Supply, REM, High-Level Pin
B+ REM IN1 REM IN2 REM OUT4 FL+ FR+ RL+ RR+ -- --
GND REM IN2 REM OUT1 REM OUT3
FL- FR- RL- RR- -- --
PWR REM REM REM Front Front Rear Rear -- --
Input Input Output Output Left Right Left Right
Input Input Input Input
Note:
“-“ is negative or inverse (ground)
“+” is positive or positive phase
7.1.1. Power
B+: Connect to car Power Supply po12V.
(It is recommended the installation of a fuse by max. 15Ah)
GND: Car Power Supply Negative
Note:
Make sure that the power connection is closely compatible with the power of
this unit. Otherwise the uni twill be damaged procuring risk of a short circuit,
fire, etc.
7.1.2. REM IN
Provided 2 sets of processor switches and control signal input interface REM IN1
and REM IN2, by other devices (such as : source device vehicle, DVD, etc.) though
the signal input to control the processor.
Note:
The REM IN input can be connected in parallel.
7.1.3. REM OUT
Provided 4 pcs “same time same voltage” output control interface REM OUT1 -
REM OUT4 to control the car amplifier. You can also use only 1 pc and join-up in
parallel of all the external car amplifier, then others as spare.
Note:
over 4 amplificators it is recommented the installation of a switch relais.
7.1.4. High-level Input
Provided left-front (FL+/FL-), righ-front (FR+/FR-), left-rear (RL+/RL-), right-rear
(RR+/RR-), 4 groups.
This high-level analog signal input cannot exceed a voltage input of 14.4 VDC.
Note:
switching on the built-in source, you will have automat12V from
REM OUT.
