Abus DIGI-LAN TV7210, Руководство по установке

Страница: 106 / 245

43
Appendix
A. Troubleshooting
LED status display
Following switch-on, the security network camera runs a diagnostic self-test to detect potential hardware
faults. The following table lists the general LED patterns. In the event of a serious fault or error, the LED
flashes differently from the patterns listed below.
Condition LED colour
During the self-test following switch-on: Blinking in interchanged Blue and Red
No Ethernet signal found: Red LED is constantly ON and Blue LED is OFF.
Before the network is set up: Red LED is constantly ON and Blue LED is OFF
After the network is set up: Red LED is constantly ON and Blue LED is blinking
every 0.5 seconds
Other hardware faults: Other patterns
Resetting and restoring
In the opening next to the I/O terminal block is a button. Press this button to reset the system or restore the
factory parameter settings. Sometimes the normal system status can be restored by a reset. If you have
further problems following a reset, restore the factory parameter settings and reinstall and reconfigure the
system.
RESET:
Press the reset button with a pointed object.
RESTORE:
1. Press the button continuously with a pointed object.
2. Wait until the self-test runs a second time.
3. Release the reset button after both LEDs shut off.
If the factory parameter settings are
restored, all the previous settings are deleted.
The system can be reset or restored.