Absima CR7P, Руководство пользователя

Страница: 56 / 92

CR7P
Digital Proportional Radio Control System
22
7.4 Failsafe
The failsafe function is used to output the channel value according to the out-of-control protection
value set by the user after the receiver loses its signal and is out of control to protect the model and
personnel.
It can also be set failsafe for each channel respectively. This receiver supports two failsafe modes:
[ON] and [OFF]
[OFF] It is no output for the interface of PWM.
[ON] Outputs the failsafe values set for each channel.
Notes:
1. For bus signal types such as PPM/i-BUS/S.BUS, a single or several of these channels are not
allowed to be in [No output] mode. The actual signal is held at the last output value when the
channel is set to [No output] mode.
2. Because the S.BUS signal information contains failsafe flag bits , the failsafe settings of each
channel are communicated to subsequent devices by the failsafe flag bits . If the connected
devices support the failsafe flag bit analysis , the failsafe values set for each channel are output
after out of control.
3. For the signal PPM/i-BUS without failsafe flag bits , it supports the setting of the signal to [No
output] mode in case of out of control. After setting to [No output] mode, regardless of the
setting of the failsafe of each channel, each channel will be in [No output] mode after out of
control.
• Power on the receiver first , then press and hold the BIND button for more than ten seconds ,
when the LED of the receiveroperates in threeflash-one-off manner repeatedly, then release
the BIND button.
• Connect the bind cable to the signnal pins of the CH4 and CH6, then power on the receiver
Notes:The method of activating the binding or mandatory updating function may vary according to
the type of receiver. For details , please refer to the user manual of the corresponding receiver.