Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
Model: ADGAZEBO33
21/09/23
1.00
6
Front
Rear
FITTING THE SHURELOCK BEAMS
NOTE: Beam orientation is important to prevent
water entry.
Orientate the beam so the exterior face has the
overlap to the top.
1.
Safely lift and place a
SB1
beam inside the
front post brackets
BK3
as shown.
Overlap to
top
Overlap to
bottom
INTERIOR
EXTERIOR
CL
4.
Safely lift and place the side beam
SB1
inside
the post brackets
BK3
as shown.
5.
Make sure the ends of the beam are as far
as they can go into the brackets, there will be a
small gap at the top for the front due to angle.
Fasten each end with four
FAST100
tek screws
as before.
6.
Repeat these steps for the other side beam
2.
Make sure the ends of the beam are all the
way into the brackets and fasten each end with
four
FAST100
tek screws.
These are visible screws so take time to position
them on the centreline of the BK3 bracket and
inset equally from the top and bottom.
3.
Repeat these steps for the rear beam before
proceeding to step 4.
On the exterior side of the rear beam only put in
the lower teks for now.
0.
Remove the protective plastic coating from
the outside of the beam.
