Absaar HF1206, Руководство пользователя

Страница: 6 / 27

10 11
1.
Charging indicator - yellow LED, when battery is charging the yellow LED is lit
2.
Full charge indicator - green LED, when the battery is fully charged or the charger switches into float charge
mode, the LED is lit; and when there is no load in the circuit, it also illuminates.
3.
Reverse polarity indicator - red LED, when battery clips are wrongly connected to the battery the LED is lit.
4.
Slide switch - You can select charging current by moving the slide switch as required.
The chart shows the charging current for the recommended battery capacity for your reference.
Charge rate Battery capacity recommended
2A Up to 30 Ah
4A Up to 75 Ah
6A Up to 110 Ah
5.
Ventilation openings - Be sure the ventilation openings are free from obstruction.
6.
DC cable - DC output cable with red (+) and black (-) clamps for connection to the battery.
7.
Power cable - connect to a standard 230V AC power outlet.
8.
Cooling fan - automatic built-in high-speed cooling fan.
OPERATION INSTRUCTIONS
· Ensure the battery charger is disconnected from the power supply.
· Connect the red charger clamp to the positive terminal of the battery (+) symbol.
· Connect the black charger clamp to the negative terminal of the battery (-) symbol.
· Choose the correct current to match the battery you wish to charge with the slide switch.
· Plug the charger into the AC mains power. The yellow LED will light up showing that the
battery is charging.
CAUTION: If the yellow charging light turns off and the red light turns on, immediately
disconnect from the AC mains power, check the polarity of the battery clips to the battery
terminals.
CAUTION: If output voltage becomes very high, the relay switches to protect against dam-
aging and shortening the life of the battery. When the voltage returns to normal, the relay
will automatically reset.
· When fully charged, the green LED light turns on. The recharge time will vary based on
the capacity and discharge state of the battery.
· Disconnect the power supply cable from the standard AC mains power outlet.
· Disconnect the black charge clamp from the negative terminal of the battery (-) symbol.
· Disconnect the red charge clamp from the positive terminal of the battery (+) symbol.
· Store the battery charger in a dry place.
INTRODUCTION
Thank you for purchasing an Absaar HF-1206 charger. It is designed to charge 12V (typically six 2 volt cells,
for detailed information refer to the battery manufacturer) rechargeable lead-acid, VRLA maintenance free (gel
and AGM) batteries with a battery capacity up to 110Ah. It is not designed to charge 6V or 24V batteries.
· The charger includes automatic protection features to ensure safety:
· Short circuit protection
· Reverse polarity protection
· Over heating protection
· Over voltage protection
· Automatic fan control
· LED indicators display charging, floating mode and reverse polarity status
THREE-STAGE BATTERY CHARGING
Multi-stage charging ensures batteries receive optimum charging:
1) Current charge
2) Constant charge
3) Floating charging
IMPORTANT SAFETY INFORMATION
Misusing or incorrectly connecting the HF-1206 battery charger may damage the equipment, on-board elec-
tronics, or create hazardous condition for users. Read the safety instructions and pay special attention to all
Cautions and Warning statements in the guide. Please keep this manual for future reference.
FEATURES
CONTENTS
I
ntroduction 10
Important Safety Information 10
Features 10
Operation Instructions 11
Troubleshooting 12
Specifications 12