13
GENERAL MAINTENANCE INFORMATION
PLEASE KEEP THIS FOR YOUR RECORDS
Links, Pull-Pins, Snap Hooks, Swivels, Weight Stack Pins:
•
Check all pieces for signs of visible wear or damage.
•
Check springs in snap hooks and pull-pins for proper tension and alignment.
•
If the spring sticks or has lost its rigidity, replace it immediately.
Upholstery:
•
To ensure prolonged upholstery life and proper hygiene, all upholstered pads should be wiped down
with a damp cloth after every workout.
•
Periodically take the time to use a mild soap or an approved vinyl upholstery cleaner to deter the
onset of cracking or drying. Avoid using any abrasive cleaners or cleaners not intended for use on vinyl.
•
Replace ripped or warn upholstery immediately.
•
Keep sharp or pointed objects clear of all upholstery.
Decals:
•
Inspect and familiarize yourself with any safety warnings or other user information posted on each unit.
Nuts and Bolts:
•
Inspect all nuts and bolts for any loosening and tighten if needed.
•
Go through a re-tightening sequence periodically to ensure that all hardware is tensioned properly.
Anti-Skid Surfaces:
•
These surfaces are designed to supply secure footing and need to be replaced if they appear worn or
become slippery.
Belts and Cables:
•
Visually inspect the belts and cables for fraying, cracking, peeling, or discoloration.
•
While the machine is not in use, carefully run your fingers along the belt or cable to feel for thinning
or bulging areas.
•
Replace belts and cables immediately at the first signs of damage or wear. Do not use equipment until
belts or cables have been replaced.
Belt and Cable Tension:
•
Referring to the Owners Manual, when belts or cables are used check all bolts attachments to be sure
they are properly attached.
•
Check slack in cables and re-adjust cable tension if needed.
Seat Sleeves, Guide Rods:
•
Before applying lubricant, wipe down applicable parts with a dust free rag.
•
Lubricate seat sleeves and Guide Rods with a Silicon or Teflon based lubricant spray.
Linear Bearings:
•
Referring to the Owners Manual carefully disassemble the bearing from its housing and place a finger
full of light grease (lithium, super lube, etc.) into the inside of the bearing. Using your finger, press the
grease into the ball-bearings and their tracks. Repeat until the ball-bearing tracks are full of grease.
Insert the shaft back into the bearing and wipe off excess grease.
