Part number 20070, Rev 0
6
SHELF INSTALLATION (not applicable to all units)
Hook shelf clips onto pilaster strips (see Illustration). Position all four shelf clips equal in
distance from the floor for flat shelves. Wire shelves are oriented so that cross support bars are
facing down.
Place shelves on shelf clips making sure all corners are seated properly.
TEMPERATURE CONTROL
NOTE: All of these controls are preset at the factory to provide the desired air and product
temperatures inside of the units and require no further adjustment. Please contact the
manufacturer’s Technical Support Department before making any adjustments to determine
if adjustment is necessary and, if so, to make sure it is performed properly.
Both refrigerators and freezers have a manual thermostat located inside the metallic sealed box
near the top rear corner of the unit. This thermostat controls the compressor. Turning the
thermostat towards the higher numbers will make the unit colder. Lower numbers will make it
warmer. Turning the thermostat to the off or 0 position will turn the unit off. For combo units
(refrigerator and freezer), this thermostat controls the compressor based on freezer
temperature. Temperature in the refrigeration compartment is controlled by venting air from
the freezer compartment
