![background image](http://html.mh-extra.com/html/abs/abt-2020mp/abt-2020mp_owners-manual_453104004.webp)
Part number 20079, Rev 0
4
INSTALLATION
UNCRATING
–
This unit comes with an optional roller base so you
can unpack it in an open area and then place it on the roller base
to move to its normal location. Remove the wooden planks or
skid as shown. These units come with a caster platform (or roller
base). To place the unit on the roller base have one person tilt
the machine forward and hold it while a second person slides the
roller base in from the back. Note that the side without a top lip
goes towards the front of the unit. Once it is in as far as it will go,
have the second person lock the rear wheels and hold the base
firmly in place while the first person tilts the machine up and onto the roller base, pushing it
back until all 4 corners are on the base. You can now unlock the rear wheels and move the unit
to its final location. The freezer should be placed as close as possible to a dedicated power
outlet so an extension cord will not be needed. This unit requires a
minimum of 4 inches of air
flow space in back and 3 inches on the sides and top.
Once the unit is in place, the rear casters
on the roller base should be locked to prevent inadvertent movement.
LEVELING
−
Once the unit is in place (either on or off of the roller base) you can level it with the
screw-type adjustable leveling legs on the front corners of the unit. Turn counterclockwise to
raise the corner; turn clockwise to lower it. The unit may have a slight tilt from front to back
after the legs are installed. This is acceptable and is actually recommended.
POWER SOURCE – The supply circuit to this cabinet
must conform to all National and Local Electrical
Codes. Consult the cabinet Serial-Data plate for
voltage, cycle, phase, and amp requirements before
making connection. VOLTAGE SHOULD NOT VARY
MORE THAN 5% FROM SERIAL PLATE RATINGS. A
separate circuit is recommended to prevent possible
loss of product due to over-loading or failure of
other equipment on the same circuit. PROTECT THE CIRCUIT WITH A 20 AMP DELAY-TYPE FUSE
OR CIRCUIT BREAKER. Do not use an extension cord. Be sure your unit is properly grounded.
Use the 3-prong plug provided into a 3-prong grounded outlet.
(Only this method complies with national electrical codes, local
codes and ordinances.) Unless the above grounding method is
followed, you are not protected against severe or lethal shock
in the event of a short circuit of an electrical component or
wiring of the unit.
STARTING – There are no compressor shipping bolts to loosen
or valves to open. All that is necessary after the unit has been
placed on the roller base and leveled is to plug the service cord
into an electrical outlet When starting this new appliance,
allow the cabinet to operate a minimum of eight hours or until