Code Button Combo Setting
Code 1
,
Code 2
and
Code 3
buttons may be programmed to turn on and off switch button controls
(
SW1
~
SW4
) and/or
SIREN
button together.
1. Press and hold
PTT
,
MAN
and
RADIO
for 5 seconds to enter
Code Button Combo Setting
.
RADIO
will
blink to indicate that you are in
Code Button Combo Setting
.
2. While in
Code Button Combo Setting,
press and select one of
Code 1
/
Code 2
/
Code 3
buttons, and
then press
SW1
~
SW4
and
SIREN
to add it into combination (indicated in Red); press these buttons
again to remove from combination (indicated in Green).
3. Repeat step 2 untill all
Code 1
~
Code 3
buttons are set.
4. Once set, press
PTT
and
HORN
buttons for 5 seconds to save and exit
Code Button Combo Setting
.
RADIO
will stop blinking to indicate that you have exited.
NOTE:
Momentatry switch will not be applied when it is activated by
Code 1
~
Code 3
buttons.
SW1
~
4
each may be set as a ON/OFF switch, a Momentary switch or a Timer switch.
1. Press and hold
PTT
,
MAN
and
Code 3
for 5 seconds to enter
SW Button Type Setting
.
2. If any of the button type is not in its default setting (ON/OFF), an auto-clearing will be performed with
a full blinking of the controller.
3.
Code 3
will blink to indicate that you are in
SW Button Type
Setting
; the button type of each
SW1~4
button is indicated with
its LED colour. (See the table below for SW button types)
Red
LED Status
Green & Red
Green
ON/OFF (default)
SW Button Type
TIMER (10 seconds)
MOMENTARY
4. Momentarily press each button to change its type.
5. Once set, press
PTT
and
HORN
buttons for 5 seconds to save and exit
SW Button Type Setting
.
Code 3
will stop blinking to indicate that you have exited.
6. Disconnect all power and power up again to apply the change.
SW Button Type Setting
<IMPORTANT>
Only alter the SW Button Type AFTER you have done setting other settings (i.e.
Volume, Tone and Code1/2/3 Combo). SW Button Type will always revert to default (ON/OFF)
whenever entering/re-entering a setting mode.
- 8 -
