Abra AK-72, Руководство пользователя

Страница: 9 / 16

9
*ATTENTION* DO NOT TOUCH THE SOLDERING IRON TIP WHEN IT IS HOT.
d) It is recommended that you clean the board with a brush, isopropyl alcohol and
lint-free cloth to get rid of any glue or dirt. This way the solder will create a
better joint with the pads.
e) Have your flush cutter handy.
f) Having a roll of paper tape helps you to keep the components in place when
soldering.
*ONLY FOR THROUGH-HOLE COMPONENTS*
g) Have a rosin flux pen or paste handy. Adding flux to the pads before soldering
the component makes the process easier.
*ATTENTION* SOLDERING SHOULD BE DONE IN A VENTILATED AREA. BREATHING
SOLDER FUMES WILL HARM YOU.
6) Start the assembly by soldering the SMD resistors, capacitors and ICs. Add an appropriate
amount of solder to one pad at a time. Place each component in its designated location
by using your pliers while heating up the previously added solder so it melts again and
covers the component lead. Once the component is stuck to its location, add solder to the
other lead/pad to secure the component and create a connection.
Repeat this process until all your resistors, capacitors and ICs are soldered on the circuit
board.
Refer to the illustrations below: