Abra AK-72, Руководство пользователя

Страница: 15 / 16

15
9) Your circuit board should look like this if you have proceeded up to step 8.
10) This kit provides a single row 2-pin header that can be used to power up the module. You
can solder them if you have access to jumper wires or a pair of alligator clips. Otherwise,
solder two pieces of wire to the positive (+) and the negative (-) leads on the board.
11) Using your brush, isopropyl alcohol and lint-free cloth, clean the board thoroughly and
make sure no flux residue is left.
12) Prepare your power supply, alligator clips and jumper wires. Follow the recommended
specs to adjust the power supply before connecting the leads. (refer to section 2.
Specification on page 2)