Copyright
2006, Delmhorst Instrument Co.
Page 14 of 32
All wood materials:
15%
Drywall:
1.0%
Concrete:
68 (on the 0-100 relative scale)
TO TAKE PIN READINGS IN ENHANCED MODE:
1.
From the Enhanced Main Menu
, use the
keys to highlight #1,
PIN MODE
.
2.
Press the SELECT key to get into the
ENHANCED READ
screen. The current
location will stay the same while toggling between scan and pin modes.
This screen contains the following information: material, pin setting, temperature
correction, Job #, alarm setting, mode, and memory used.
3.
Insert the pins into the material. The meter will
start taking measurements in
one of the two following ways, depending on whether it is set for
CONTINUOUS
or
TRIGGERED
mode. To choose between
TRIGGERED
or
CONTINUOUS
, use
the
and
keys to highlight
MODE
, and then press the
SELECT
key to
toggle between
TRIG
and
CONT.
•
When the meter is set to Triggered mode
, a single reading is taken
every time the
SELECT
button is pressed. Each reading is stored in
memory. The last measurement remains displayed on the screen.
•
When the meter is set to Continuous mode
, press
SELECT
key to
initiate the reading cycle. The meter keeps taking MC readings in this
mode. These readings are NOT stored until the
SELECT
key is pressed
again. To exit continuous mode WITHOUT STORING the current reading,
press any directional key (
and
).
To exit continuous mode
and STORE the current reading, press the
SELECT
key. Exiting
continuous mode leaves the last reading on the screen. To resume
continuous mode, press the
SELECT
key again. Use the
and
keys to choose a different option.
4. At any time, you may modify Temperature (T).
The
EXIT
option in both
SCAN
and
PIN MODE
menus will cancel the
measurement process and will put the meter in the
MAIN MENU
.
TO TAKE SCAN READINGS IN ENHANCED MODE:
