Copyright
2006, Delmhorst Instrument Co.
Page 10 of 32
2.
You may begin taking readings
by firmly pressing the back of the meter onto
the material. This will display a relative reading that ranges between 0 and 300.
TO SET THE ALARM IN BASIC SCAN MODE:
1.
If you wish to set the alarm
to beep after a pre-selected relative value is
reached, use the
keys from the
SCAN
screen to highlight the
ALARM
.
Press the
SELECT
key to enter the alarm sub menu.
2.
The default status of the alarm is “OFF.”
Press the
SELECT
key to turn it on.
3.
After the alarm is turned on, use the
keys to scroll up or down to a
higher or lower alarm value.
4.
After you have selected the alarm value
, use the
key to highlight
DONE.
Press
SELECT
to get back to the
SCAN
screen.
Note: Default alarm settings for SCAN mode is 300.
TO TAKE TEMP/RH READINGS IN BASIC MODE:
Before entering the RH-T mode, firmly insert the RH/T-S1 sensor into the top of the
meter, making sure to align the pin-out on the DIN connector.
1.
From the BASIC Main Menu
, use the
key to highlight
RH-T
MODE
.
Then, press the
SELECT
key to get into the
RH-T
mode main menu.
The meter will display the main
RH-T
mode main menu, as shown below:
