ABM International, Inc.
Series 1081 & 1026
Version 5.0
Users Guide
Proprietary information of ABM INTERNATIONAL, Inc. furnished for customer use only.
No other uses are authorized without prior written permission of
ABM INTERNATIONAL, INC.
5
SECTION 2.0 – Machine Setup
The Innova ships fully tested ready to operate. As a result, this manual provides a section on machine setup so that
you can install the machine. Please read this manual in its entirety and follow all ABM instructions, especially the
inspections. Total setup time will take approximately 1 hour.
SETUP INSTRUCTIONS:
INSPECTION #1:
Upon receipt of the machine, check to ensure that there is no visible damage. Figure 0.1 and
the front cover of this manual are enough for this inspection. Note: that some components may be in different
locations depending on the version of the machine.
Determine the location in your facility for the quilting machine. Once a final position has been determined for the
machine, plug it into your 110 volt receptacle, coil any excess cable and wire tie it to the table of the machine,
which will reduce the risk of a tripping hazard.
The machine comes equipped with a 110V plug, and should be plugged directly into the wall receptacle or a surge
protector (not supplied). ABM does not recommend the use of any type of extension cord to power the machine.
As with any machine, power should be run properly through approved ducting with proper termination. You may
connect the power to the machine at this time.
INSPECTION #2:
Will confirm that the electronics of the Innova long arm quilting machine are functioning
properly.
WARNING
: ELECTRICAL SHOCK HAZARD. NEVER ATTEMPT TO
WORK ON OR OPERATE THE MACHINE WHILE THE ELECTRICAL
COVERS ARE REMOVED. WHENEVER REMOVING THE ELECTRICAL
COVERS PLEASE BE CERTAIN TO TURN-OFF THE MACHINE AND
UNPLUG THE POWER RECEPTICAL.
Upon power up, the PLC should power up and show up on the LCD. If this does not occur, check for incoming
voltage at the outlet.
WARNING
– WHEN OPERATING THE MACHINE, YOU MUST ENSURE THAT THERE
ARE NO LOOSE ITEMS SUCH AS TOOLS, FOOD, DRINKS, ETC. ON THE MACHINE AND
THAT ALL PERSONNEL ARE CLEAR OF THE MACHINE.