13
190924_REV.2
3. Putting device into operation
①
After cleaning of assembled Base plate and Motor, place into incubator.
②
Put motor cable outside from the utility port of incubator.
③
Connect power cable to the power cable port of Controller. Connect motor cable to
the rear port of controller. Align the notch of the port and motor cable connector and
push until it clicks. (DO NOT twist connector and cable)
④
Connect the power cable to the power supply.
When operating the assembled motor and base plate side by side with the
controller on a table, install at least 30 cm apart.
NEVER use acetone, acid or alkali water for cleaning.
NB: In setting up Cultistir, please observe the conditions for location and
setting up as outlined in section
Ⅰ
.
4. Disconnect the cables
①
Disconnect motor cable from rear port of the Controller. Pull the release ring of the
connector of motor cable. (DO NOT pull the cable)
②
Disconnect the power cable.
NB: When disconnecting motor cable and power cable from Controller the
latter must always first be switched off otherwise the electronics may be
damaged.
