Ref: "ProgGuide1_7.docx"
Page 14 of 26
Document Revision: “1.7”
Document Date: “11 Sep. 2013”
Formatting Commands (Continued)
HTAB
09H
Horizontal Tab
Default positions: 8,16,24,32,40;
6 positions available; programmed using ESC,D command. Ignored if off the end of a line. The first
HTAB does not move from a HTAB position to the next:
e.g.
1234567890123456
123456 T
(1 Tab before "T")
1234567T
(1 Tab before "T")
1234567 T
(2 Tabs before "T")
12345678 T
(1 Tab before "T")
LF
0AH
Line Feed
Works in an either/or way with CR: CR/LF pairs are treated as a single line terminator. Line
terminators immediately following full lines are ignored.
FF
0CH
(Real time) Form Feed
+
Exit spooling mode and print buffer contents.
Ignored if the printer is not already in spooling mode or an error condition exists.
CR
0DH
Carriage Return
@
Line terminator: works in an either/or way with LF. CR/LF pairs are treated as a single line
terminator
ESC," ",..
1BH,20H,n
Set right-of-character spacing
n is the number of additional (note!) dot spaces placed to the right of each character printed.
Default= 0; maximum value= 31. Setting is retained until cleared or the printer enters sleep mode.
