Call us on
1300 368 831
or visit
www.thermogroup.com.au
1. The mirrors are supplied with wall plugs and screws however these are not suitable
for all wall types. If this fixing is not suitable for the wall alternate fixings will need to
be obtained.
2. Measure the distance between the hangers on the mirror and mark your wall using a
spirit level.
3. Drill 6mm holes in the positions marked insert the wall plugs provided.
4. Insert the screw through the tongue wall hanger and screw into position. The hangers
provided have 20mm vertical adjustment if required.
5. Lower the mirror onto the hangers on the wall with care. You can adjust the mirror
up or down for any minor height adjustments or leveling of the mirror by loosening
the screw and sliding the tongue wall hanger up and down.
6. Follow the care instructions on the next page.
Installation Steps | Metal Bracket Mounting Method
PLEASE NOTE:
• The mirrors are provided with metal hanger plates on the back of the mirror for either
landscape or portrait mounting. The mirror is designed to hang on the top plates. You
will use two hangers for smaller mirrors and three hangers for larger mirrors. Please note
not all of the hangers will be used.
• A foam square is also attached to the back of the mirror to keep the mirror level.
50mm
90mm
90mm
45mm
Key:
1.
Wall
2.
Wall Plug
3.
Tongue Wall Hanger
4.
Screw
5.
Hanger
6.
Mirror
6
5
2
1
4
3
METAL HANGER PLATE ON BACK OF MIRROR
TONGUE WALL
HANGERS INCLUDED
45mm
25mm
20mm
8.5mm
