Safety and Operating nOticeS
3
• To disconnect the device completely from the power grid, the power supply must be
cut at your domestic miniature circuit breaker (MCB).
• Follow all information and instructions of the manufacturer for installing and operat-
ing the device.
• Do not operate the device in confined spaces.
• Make sure that the front cover shield is always locked to prevent unauthorized open-
ing of the housing. Keep the key in a place that is known to all authorized users.
• You must under no circumstances make any changes to the housing or the internal
wiring of the device: Any disregard of this instruction fundamentally breaches the
guarantee provisions and voids the warranty with immediate effect.
• No parts to be maintained by the user are located inside the device.
• Only have qualified, specialist personnel repair and/or install the device.
WARNING!
This wallbox is intended for connection to and operation on 230 or 230
/ 400 V 50 Hz mains power only. Power supply cables may be installed
below or above the wall surface. The cable should enter the device via the
rubber seal in the lower area of rear part of the housing (see page 10).
• Only use a dry cloth to clean the device. Do not use aggressive cleaning agents,
waxes or solvents (such as cleaning fluid or paint thinner), because they can dull the
displays on the device.
• The wallbox must never be cleaned using a pressure cleaner or similar implement.
• Check the permanently installed charging cable of your eMH1 wallbox regularly for
potential abrasions or damage.
DANGER!
Should you discover any damage to the charging cable or a supply cable,
you must take the device out of operation immediately. In this case,
please turn to an authorized service partner or the dealer from whom
you purchased the product. You must not under any circumstances at-
tempt to resolve or
repair any damage or malfunction yourself!
• Relevant local regulations for operating electrical devices always apply.
