inStallatiOn and pOwer Supply cOnnectiOn
10
3. If you do not wish to pass the supply cable cen-
trally through the rear part of the wallbox, find the
pre-stamped cable inlets on the edge of the wall
bracket: Chose one of the pre-stamped cable in-
lets on the upper, lower, left or right edge and
use the cutter to cut an opening to suit the power
supply cable into the edging.
4.
Pass the supply cable to the central opening on
the rea side of the wall bracket from where you
can access the cable inlet on the rear part of the
wallbox. If required, you can use cable ties to fix
the supply cable to the tabs on the back of the
wall bracket.
5.
Use the cutter to cut an opening to suit the power
supply cable into the membrane of the rubber
seal of the cable inlet. If necessary, remove the
rubber seal for this purpose and place it back into
the cable inlet afterwards.
6.
Insert the supply cable through the rubber seal
into the wallbox.
7. Fic the wall bracket in position using the included 5 x 60 torx-headed screws.
8. Seal the openings on the wall bracket with the included sealing grommets.
Electrical installation of your the wallbox
The electrical connection of the EVSE 803/813 to your domestic power supply and
taking it into operation must always be carried out by a qualified person or specialist
electrical contractor. All local norms and regulations regarding the installation of electri-
cal devices must be observed.
DANGER!
Ensure that the upstream MCB in the domestic power distribution box
and the integrated RCCB of the wallbox have both been deactivated: The
power supply cable must be voltage-free under all circumstances before
you or any third person manipulate the power supply in any way.
Read and make sure that you follow all safety notices in this manual and
those on the wallbox itself!
1. Fix the supply cable in place using the dedicated strain relief in the lower part of the
rear part of the EVSE 803/813 housing.
2. If using a power supply with flexible wires, ensure that the stripped ends are fitted
with wire end ferrules.
Rear view
of the wall bracket
