ABL eMH1 513, Инструкция по эксплуатации, Страница: 13 / 20

Product overvIew Assembly
5
Assembly
Assembly location
The charging station is designed for outdoor use (splash proof). In order to best protect
the appearance of the charging station, it should only be installed in locations that are
not exposed to constant, direct sunlight. We recommend installing the charging station
in a garage or carport.
Opening the charging station (Fig. B)
1. Open the housing cover (B1)
2. Loosen the fastening screws (B2)
3. Remove the upper housing (B3)
Attaching the charging station (Fig. C)
1. Check the installation site (floor, routing of cable to be connected)
2. Drill a hole for feeding the cable through the lower housing (centre points!)
3. Drill holes into the wall (drilling template)
4. Hang the charging station on attachment point C1
(4-mm Ø cylinder head screw with 8-mm Ø head)
5. Attach the charging station to attachment point C2 with 4-mm Ø cylinder head
screw
6. Connect power supply (see electrical connection) and attach with strain relief (C3)
Ensure solid mounting of the housing base, particularly for the lower part, because this
is where the tensile forces of the charging cable are absorbed.
Use the drilling templates to mark drill hole positions for wall installation. The mounting
surface must measure at least 260 mm x 220 mm!