erstellt:
geändert:
HF Transceiver Sender CSxxxTRT-1-1
Name:
ORD
MK
mit Rückmelde-Funktion
Datum:
02.02.2015
25.07.2019
Art.-Nr.: KH66983xxx61.A
Seite
2
von
9
01 Description
The CSxxxTRT-1-1 RF part is a transceiver with multiple functions:
1. Transmitting or Receiving (simplex or halfduplex)
2. “Feedback Master” or “-Slave” for 3 LED-Feedback (halfduplex).
The functions are selectable by SIP-Switch for frequency allocations and solder jumper to select
Transmitter/Receiver, FB-Master or FB-Slave.
The TRT (CSxxxTRT-1-1) has four holes to be mounted on screw bosses or it is mounted in
module slots in transmitter housings.
The counterpart of the TRT is the TRR (CSxxxTRR) module which is formed to be used in
receivers.
The TRT has an ISP port (In System Programming) which makes it possible to download new
firmware.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)
This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
(2)
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
‐
Reorient or relocate the receiving antenna.
‐
Increase the separation between the equipment and the receiver.
‐
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐
RF Radiation Hazard Warning (products with activated transmit option only): To ensure
compliance with FCC RF exposure requirements, this product should be positioned no less than 20
cm from your body or nearby persons during continuous use.
