Hardware Setup
2-3
2.3. Install
Pentium
®
4 CPU and Heatsink Supporting-Base
This motherboard provides a ZIF
(
Z
ero
I
nsertion
F
orce) Socket 478
to install Intel
®
Pentium
®
4 CPU.
The CPU you bought should have a
kit of heatsink and cooling fan along
with. If that’s not the case, buy one
specially designed for Pentium
®
4
Socket 478.
1. Locate the 478-pin ZIF socket
on the motherboard. Fasten the
Retention Module Base onto the
motherboard.
ATTENTION:
If you are using
chassis specially designed for
Pentium
®
4, please pay attention to
the location of metal studs or
spacers if they are already installed
on the chassis. Be careful not let the
metal studs or spacers contact the
printed circuit wire or parts on the
PCB.
2. Pull the CPU socket lever
sideways away from the socket
and then upwards to 90 degree.
Insert the CPU with the correct
orientation. Do not use extra
force to insert CPU; it only fits
in one orientation. Close down
the socket lever while holding
down the CPU.
3. Put the heatsink faces down
onto the CPU until it completely
covers the CPU.
4. Put the Fan and Retention Mechanism Assembly onto the heatsink. Make sure all
the four Retention Locks at each side of the Fan and Retention Mechanism
Assembly snap into the Retention Holes.
User’s Manual
Содержание SI-1NS
Страница 1: ...SI 1Ns Socket 478 Server Board User s Manual 4200 0353 02 Rev 1 00 ...
Страница 7: ...Introduction 1 3 1 2 Layout Diagram User s Manual ...
Страница 20: ...2 12 Chapter 2 2 5 8 COM Port Header This header provides one external COM2 port connection SI 1Ns ...
Страница 29: ...BIOS Setup 3 7 Small Logo EPA Show This item determines to show the EPA logo when booting User s Manual ...