Abit PX5, Руководство пользователя

Страница: 80 / 90

Appendix E E-4
Installing two HDDs:
The red line on the connection cable must be lined up with pin 1 on the connector.
Method 1: Set the hard disk drive used for boot up at Master, and the
other drive at Slave. Connect one of the connectors of the
40-pin cable to the first drive, another connector to the second
drive, and the other end of the cable to connector IDE1 on the
mainboard.
Method 2: Set the hard disk drive used for boot up at Master, connect
one end of the 40-pin cable to the drive, and the other end to
connector IDE1 on the mainboard.
Set the other hard disk drive at Master, connect one end of the
40-pin cable to the drive, and the other end to connector IDE2
on the mainboard.
Installing two HDDs + one CD-ROM drive:
The red line on the connection cable must be lined up
with pin 1 on the connector.
Method 1: Set the hard disk drive used for boot up as Master, set the
other HDD at Slave, connect one connector of the 40-pin
cable to the first drive, another connector to the second drive,
and the other end of the cable to connector IDE1 on the
mainboard.
You can ignore the setting of the CD-ROM drive. Connect
one end of the 40-pin cable to the drive, and the other end to
connector IDE2 on the mainboard.
We recommend you use this method, which has no influence
on HDD speed.
Method 2: Set the hard disk drive used for boot up at Master, connect
one end of the 40-pin cable to the drive, and the other end to
connector IDE1 on the mainboard.
Set the other hard disk drive at Master, and be sure that the
CD-ROM drive is set at Slave. Most of CD-ROM drives are
set at Slave as a default, so you will normally not have to set
the CD-ROM drive. After you have verified the settings,
connect one connector of the 40-pin cable to the HDD,
another connector to the CD-ROM drive, and the other end of
the cable to connector IDE2 on the mainboard.