BIOS Setup
3-9
!
AGP Driving Value:
Leave this item to its default setting.
AGP Fast Write:
Two options are available: Disabled
$
Enabled. The default setting is
Enabled
. If your AGP adapter can
support this function, then you can choose
Enabled
. Otherwise, choose
Disabled
.
AGP Master 1 WS Write:
Two options are available: Disabled
$
Enabled. The default setting is
Disabled
. This implements a
single delay when writing to the AGP Bus. When you set it to
Enabled
, two-wait states are used by the
system, allowing for greater stability.
AGP Master 1 WS Read:
Two options are available: Disabled
$
Enabled. The default setting is
Disabled
. This implements a
single delay when reading to the AGP Bus. When you set it to
Enabled
, two-wait states are used by the
system, allowing for greater stability.
AGP 3.0 Calibration cycle:
Leave this item to its default setting.
#
DRAM Clock/Drive Control:
Click <Enter> key to enter its submenu:
Phoenix – Award WorkstationBIOS CMOS Setup Utility
DRAM Cloc /Drive Control
k
Current CPU Frequency
Item Help
Current DRAM Frequency
DRAM Clock(Mhz)
Auto
DRAM Command Rate
Auto
DRAM CAS# latency Time
Auto
↑↓
:Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Current CPU Frequency:
This item will show you the current system front side bus speed.
Current DRAM Frequency:
This item will show you the current DRAM bus speed.
User’s Manual
