73
1.16 ERROR CODE
Error Code Problems
Solutions
E01
Connection fails
between “PCB” and
“Lower Control Board”
6.
Check every wire is connected well
between PCB and lower control
board.
7.
Check if any of the wire is damaged.
8.
Check if PCB or lower control board is
in good condition. If any chip is
damaged, change PCB or lower
control board.
E02
Over-loading Protection 7.
Check if power outlet has low voltage
supply. If so, change a different
power outlet.
8.
Check if lower control board has bad
smell. If so, change a lower control
board.
9.
Check if wires connected to motor
are well connected.
E03
Speed Sensor Error
5.
Check the speed sensor is well
connected or not.
6.
Replace the speed sensor.
E05
Over-current Protection
9.
Check if any part on motor is stuck.
Un-plug power cable and adjust or
change a motor. Plug back in the
power cable and re-start to run the
treadmill.
10.
Check if motor has burned smell. If so,
change a motor.
11.
Check if lower control board has
burned smell. If so, change a lower
control board.
12.
Check if power outlet has low voltage
supply. If so, change a different
power outlet.
E06
Controller Error from Self
Examination
4.
Try to start the treadmill to check if
motor runs. If not, check the wires of
motor are well connected.
5.
Check if the protector tube of lower
control board is loosened or
damaged. If so, re-plug the wire or
change a new one.
