48
MAINTENANCE
Part
Recomended maintenance
How
often?
Cleaning
Lubrication
Display
Clean with a soft, clean and moist
cloth.
After
use
No
No
Frame
Clean with a soft, clean and moist
cloth.
After
use
Water
No
Running
belt
Clean with a soft, clean and moist
cloth.
Weekly
No
No
Running
deck
Clean with a soft, clean and moist
cloth. Make sure that it has
sufficient applied lubricant and
the surface is smooth.
Weekly
No
Yes*
Drive belt
Inspect that the drive belt is
sufficiently tight, check for any
wear and that drivebelt is in the
correct position.
Monthly
No
No
Bolts, nuts
etc.
Inspect all bolts, nuts and screws.
Thighten if necessary.
Monthly
No
No
* Always use the manufacturer's recommended lubricant
Care
For cleaning the running belt use a vacuum cleaner. If the belt is really dirty, please
use a wet cloth. Do not use any cleanser. When cleaning, use only a moist cloth
and avoid harsh cleaning agents. Ensure that no moisture comes into the computer.
Components that come into contact with perspiration, need cleaning only with a
damp cloth
Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before
leaving the manufacturing plant. Silicone oil is without volatility and has gradually
permeated through the running belt. There will be no need to re-spread the oil in
normal circumstances. To maintain the running belt, we have included a small bottle
of "Silicone Oil". "Silicone Oil" may be re-spread once the resistance has been
increased and the running belt starts rubbing against the running deck. To hold
open the running belt from two sides, apply the silicone oil with an even motion on
the center of the running deck. Allow the silicone oil to
‘set’ for on
e minute before
using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment.
In addition, do not add any other oil ingredient; otherwise the treadmill will be
damaged. Do not over-lubricate the walking board. Excess lubricant should be
wiped off with a clean towel.
Содержание Mill 2.0
Страница 1: ...1 Abilica Mill 2 0 Norsk Svensk English...
Страница 3: ...3 DELETEGNING SPR NGSKISS PARTS DRAWING...