Abilia Emfit 464000, Руководство пользователя

Страница: 15 / 32

15
4.4. Signal sounds
There are two types of signal sounds.
Alarm signals, that are long and loud, are used to notify about fast movements and bed exit. Alarm
signals can be muted using the DIP switches (see section
3.1.4 Adjust the notification sound
volume
).
Information signals, that are short and quieter than alarm signals, are used as feedback to the
user. Information signals tell the user when the device is turned on or off or when alarm signal is
acknowledged. Possible malfunctions of the equipment (disconnected bed sensor, empty batteries)
and feedback about calibration of the sensor are also notified with information signals. Information
signals can’t be muted.
Alarm signals are high priority signals that will overrule information signals if both signals activate
simultaneously.
4.4.1. Alarm signals
Two high and low “BEEPS” in a loop. Fast movements alarm goes off.
Three high and low “BEEPS” in a loop. Bed exit alarm goes off.
4.4.2. Information signals
Short, high “BEEP”. SW1 is pressed and device turns on.
Short, low “BEEP”. SW1 is pressed and device is turned off.
Short, low “BEEP” x 2. SW1 has been pressed once and alarm signal is
acknowledged.
Short, high “BEEP” x 3 and short low “BEEP”
x 3.
Sensor is disconnected or broken. Information
signal sounds after 10 seconds of disconnection
and then every 45 seconds.
Short, high “BEEP”, short “LOW” beep. Batteries are empty. Replace batteries.
Short, high “BU-BEEP” x 3. Sensitivity calibration has started / successful
calibration.
Short, low “BEEP” (after calibration). Sensitivity too low.
Short, low “BEEP” (after calibration) x 2. Sensitivity too high.