9
ALPHA 1 SLIP-ON NOZZLE: CONSUMABLE COMBINATIONS
Note: The ALPHA 1 is available with a slip-on nozzle only
ALPHA 1
Wire Size
Contact Tip
Tip Holder
Diffusor
Nozzle
Neck Liner
Cable Liner
Slip-On
Type
Part #
Part #
Part #
Part #
Part #
Part #
.024
Steel
140.0005 N/A
N/A 145.0075
S2435
SI-2435-17PT
.030
Steel
140.0051 N/A
N/A 145.0075
S2435
SI-2435-17PT
Factory Set-up
.035 Steel
140.0169
N/A
N/A
145.0075
S2435
SI-2435-17PT
.030
Aluminum
141.0001 N/A
N/A 145.0075
B2440
127.9009
.035
Aluminum
141.0004 N/A
N/A 145.0075
B2440
127.9003
Assembly instructions for direct plug
connector kits: external gas (Lincoln std. shown)
1. Slide the insulating sleeve over the connector plug (wide end facing the torch) and
screw the plug into the torch rear end.
2. Tighten down the set screw with the Allen key provided.
3. Remove the gas seal and save for possible future use (e.g. for converting the torch to
internal gas). Install the gas nipple in place of the gas seal (removable sealant can be
applied to the threads if so desired, but use care to avoid sealant getting inside the
block).
4. Slide the gas hose over the gas nipple and clamp with the clamps supplied.
5. Connect the appropriate end of the trigger lead jumper supplied in the kit to the con-
nector from the torch rear end.
6. Install the liner supplied with the torch as per installation instructions on pages 4-5.
7. The torch is now ready to install into the feeder. Finally, hook up the gas and trigger
connectors on the feeder side.
Gas seal
Gas
nipple
Set screw
Insulating
sleeve
Connector plug
Allen key
Connector Kit
Lincoln
Standard
Direct Plug
Torch Rear End
Trigger lead jumper
Gas hose
10
