abco STR1800 LPG, Руководство по эксплуатации

Страница: 22 / 25

23
F aults, fault indications and remedy
7
Fault Possible cause Solution
No function display of the control
panel Ignition key not turned to position I Insert, turn ignition key
Battery not connected Connect battery
Battery flat Charge battery
Error in plug-in connections/wiring harness Contact manufacturer
Defective fuse Check cause, replace fuse
Engine will not start
Ignition key not turned to position I Insert, turn ignition key
Battery not connected Connect battery
Battery flat Charge battery
Error in plug-in connections/wiring harness Contact manufacturer
Defective fuse Check cause, replace fuse
Diesel/petrol or gas tank empty, gas cylinder
closed Replenish fuel, or replace or open the gas
cylinder
Engine will not ignite (smells of fuel) Spark plugs defective, replace
Air filter very dirty Clean or exchange air filter
Diesel: Preheating time not reached Wait for the preheating time
(see chapter 5)
Seat contact switch not activated Operator must sit on the seat
Starter battery flat
Charge battery
Sweeping rollers/ side brush
without a function
Switch without a function Contact manufacturer
Valves on the hydraulics block will not switch Check service connections, contact
Service
Defective fuse Check cause, replace fuse
main broom housing blocked Full debris container Emptying debris container
Side brushes or main broom worn Readjust or exchange
Main broom housing rubber skirts worn or
damaged Check and exchange
Main brooms blocked by heavy debris, wires,
etc. Disassemble main brooms and remove
blockages
Main broom housing blocked Remove main brooms and clean housing
Sweeping rollers very dirty dried sweepings Cleaning the sweeping rollers
dust development hight,
unsatisfying filter performance Side brooms are raising dust Lift and switch off side brooms
Fan without function check ease of fan run, remove blockages
Filter fully loaded Use filter shaker, disassemble filter and
clean it with pressed air (from filtered
side only!)
Filter not installed correctly / gasket damaged Check the location of the filter, Replace
seal
Air leakage inside the filter chamber / move
leak air Check filter chamber and sealings
Main broom housing rubber skirts worn or
damaged Check and exchange
Not moving
Engine is not working Start engine
The operator must be sitting on the seat
Hydraulic oil volume too low Top up hydraulic oil
Drive wheel blocked Identify cause, contact manufacturer
Bowden cables of drive pedals adjusted,
jammed, cracked Check, readjust, clean, oil and replace if
necessary.
Fuses for engine control unit defective Refer to the operating manual for the
respective engine and replace the fuse.