Step 29
Page 34
å
Fasten the DRAWER FRONT MOLDING (K) to the
DRAWER FRONT (J). Use two BROWN 1" FLAT HEAD
SCREWS (12S) in the exact holes shown.
å
Insert the DRAWER SIDES (D14 and D15) at an angle
into the slot at each end of the DRAWER FRONT (J).
å
Slide the DRAWER BOTTOM (D716) into the
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (J).
å
Fasten the DRAWER BACK (D78) to the DRAWER
SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
1
2
3
4
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Groove
J
D15
D716
D14
Unfinished
surface
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
30S
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used for the DRAWER SIDES)
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
J
D15
D14
D15
D14
D78
J
K
BROWN 1" FLAT HEAD SCREW
(2 used for the MOLDING)
12S